100pcs 15K ohm Resistor 1/4w (0.25 Watt) ±1% Tolerance Metal Film Fixed Resistor, Multiple Values of Resistance Optional

They work as expected

Needed them to replace bad parts on my vehicle instrument panel.Worked great!

Just what the description says.

This worked on my ls swapped 944, the tach in the 944 would not pick up the weak 5 volt signal from the ls pcm...installed this in line with the tach signal wire and the factory tach stated working..

Fortunately I did not really need 1 percent tolerance, because these average 2.5% low. Some of us have calibrated equipment, and exercise proper cross check procedures. These do not pass. Do not rely on the "1%" specification.

Installed aftermarket seats in my car and wanted to get rid of the airbag light they caused. Found the resistance in the airbag was the same as these resistors and installed them. Airbag light is gone and no codes stored in system. Had to do some light electrical work to install them but only took a few minutes.

Came as a tape roll, not loose, which is good as I prefer the tape roll. Randomly tested about 20 resistors, all were within spec. Perfect for my purposes.

The product is great but I dont know why I bought 100, I am never going to use 100 :thumbsup:

I used this resistor for the jeep 3.0L swirl valve delete/ bypass and works perfectly.

I measured the resistance on these with my multimeter, they are in fact 3.6k ohm as advertised.

I was hoping for a thicker metal and not so flimsy but they do not work just fine.

Shipping was fast and I got my item sooner than expected.Product also matched with the listing and description.Overall, services was excellent. Definitely recommend!

Cheap and good quality. And the 100 pieces is a nice bonus. I used these resistors in place of my car's side airbags in the seats to mimic the circuit and it worked great. No SRS dash light.